Friday, September 9, 2011

Positives of burning coal!

Natural gas has been recommended as the best transition fuel as the world moves into clean energy in a phased manner. But natural gas has not been without its own share of woes.

Although the burning of natural gas emits far less carbon dioxide than coal, a new study concludes that a greater reliance on natural gas would fail to significantly slow down climate change. While coal use causes warming through emission of heat-trapping carbon dioxide, it also releases comparatively large amounts of sulfates and other particles that, although detrimental to the environment, cool the planet by blocking incoming sunlight.

The situation is further complicated by uncertainty over the amount of methane that leaks from natural gas operations. Methane is an especially potent greenhouse gas.

A worldwide, partial shift from coal to natural gas would slightly accelerate climate change through at least 2050, even if no methane leaked from natural gas operations, and through as late as 2140 if there were substantial leaks. After that, the greater reliance on natural gas would begin to slow down the increase in global average temperature, but only by a few tenths of a degree.

The burning of coal releases more carbon dioxide than other fossil fuels, as well as comparatively high levels of other pollutants, including sulfur dioxide, nitrogen oxides, and particles such as ash. Since natural gas emits lower levels of these pollutants, some energy experts have proposed greater reliance on that fuel source as a way to slow down global warming and reduce the impacts of energy use on the environment.

But the effects of natural gas on climate change have been difficult to calculate. Recent studies have come to conflicting conclusions about whether a shift to natural gas would significantly slow the rate of climate change, in part because of uncertainty about the extent of methane leaks.

The study which used computer simulations that an increase advantage in shift to natural gas is offset by the loss of cooling due to particulates! Remember these particulates are bad for health, but have this effect on climate. Just goes to show we are far away from mastering our environment!

Wednesday, September 7, 2011

Arctic ice melting faster



New data from the National Snow and Ice Data Center shows that extent of Arctic sea ice in August melted off to the second lowest amount for the month on record. Throughout the month sea ice was near levels witnessed in 2007, when the yearly record low was set. It's expected that sometime by mid-September the annual minimum will be set.

On August 31, 2011 Arctic sea ice extent was 4.63 million square kilometers (1.79 million square miles). This is 100,000 square kilometers (38,600 square miles) higher than the previous record low for the same day of the year, set in 2007. As of September 5, ice extent had fallen below the minimum ice extents in September 2010 and 2008 (previously the third- and second-lowest minima in the satellite record). If ice stopped declining in extent today it would be the second-lowest minimum extent in the satellite record.

Not only will the melting ice spell doom for the polar bears and other life, but it will also add to global warming. This is because the white colour of ice reflcets sunlight back but once melted the darker waters will absorb heat. Well, there are some who will heave sighs of relief as drilling in the Arctic will not need special ice-breaking ships, etc!

Tuesday, September 6, 2011

Solar PV fastest growing industry

In 2010, the photovoltaic (PV) industry production more than doubled and reached a world-wide production volume of 23.5 gigawatt (GW) of photovoltaic modules, according to the tenth edition of the JRC PV Status Report.

Since 1990, photovoltaic module production has increased more than 500-fold from 46 megawatts (MW) to 23.5 GW in 2010, which makes photovoltaics one of the fastest-growing industries at present.

In 2010, the world-wide photovoltaic production more than doubled, driven by major increases in Europe. For 2010 the annual market volume of newly-installed solar photovoltaic electricity systems varies between 17 and 19 GW, depending on estimates. This represents mostly the grid-connected photovoltaic market, as there are no reliable estimates available for the non grid-connected market.

The report, published by the European Commission's Joint Research Centre (JRC) shows that with a cumulative installed capacity of over 29 GW, the European Union is leading in PV installations. By the end of 2010, European photovoltaic installations provided more than 70% of the total world-wide solar photovoltaic electricity generation capacity.

Current solar cell technologies are well established with sufficient efficiency and energy output for at least 25 years of lifetime. This reliability, in addition to the increasing potential of electricity interruption from grid overloads, and the rise of electricity prices from conventional energy sources, add to the attractiveness of photovoltaic systems.

A special feature is the dramatic price reduction for solar modules by almost 50% over the last three years. This can be explained by the evolution from a supply to a demand-driven market and the resulting over-capacity for solar modules. Business analysts predict that investments in PV technology could double from € 35-40 billion in 2010 to over € 70 billion in 2015, while they expect prices for consumers to continuously decrease.

Monday, September 5, 2011

Tried and tested

A recent study in the US looked at a comparison of CFLs and LEDs. The claim has been that LEDs are more efficient than CFLs. LEDs also cost more than CFLs but they last longer, so you’ll make up the initial cost over the lifetime of the bulb. Are these facts really true?

What the survey found was that lab conditions differed from 'real world' conditions. In a lab, which can be controlled for the best possible conditions, light can be generated at optimal efficiency. Because manufacturers are able to utilize components that are made to work together, they can claim to produce results with greater efficiency.

For instance, a leading LED-chip manufacturer announced they had achieved an efficiency of 231 lumens per watt in an LED chip. However, this was conducted in a lab where technicians were able to use lighting fixtures capable of producing such high output. In the “real world,” this LED-chip manufacturer does not sell a LED lighting fixture with a claimed efficiency over 75 lumens per watt.

Therefore, among other factors, consumers would not be able to produce as high efficiency in their own homes.

For the study, they used two roughly equivalent CFL and LED lamps that would commonly be used in the home. When comparing the two on paper, the efficiency of the bulbs is nearly identical, within 0.5 lumens per watt. However, with the “real world” being taken into consideration, there are certain environmental and consumer factors that make a case for both.

One factor is cost. If your primary concern is price, the CFL would be a better choice. Although the CFL has a shorter lifespan, even if you replaced the CFL three times to achieve an equivalent lifespan to the LED, you’d still have spent lesser than on the LED.

The bottom line is that in a household setting, where optimal components and ideal conditions cannot be controlled, the LED and CFL light bulb are very close competitors. The decision for one over the other should be made based on the need.

But in terms of quality of lumens delivered, ask any electrical engineer and he will tell you that the good old T5 FTL (or tubelight) is the best! While a CFL gives 50-65lumen/watt, the T5 or T8 gives up to 95 lumen/watt. Lamp life too is lesser for CFLs.

Then why are organizations connected to energy efficiency promoting CFLs? Any idea?

Less leads to more

Is the Jevons Paradox true? Is energy efficiency really a dud?

Let's look at what the Paradox says. Jevons Paradox is named after William Jevons, who observed in the 19th century that an increase in the efficiency of using coal to produce energy tended to increase consumption, rather than reduce it. Why? Because, Jevons argued, the cheaper price of coal-produced energy encouraged people to find innovative new ways to consume energy.

Jevons paradox, is really an extreme statement about an effect economists commonly observe called "rebound": some of the gains from energy efficiency are lost because people's consumption rises in response to lower prices.

For instance, when government requires more fuel-efficient cars, aggregate demand by cars for gas is less. So prices tend to decline, and (to a limited effect) that lower price motivates a few people to drive a little more than they might have, perhaps taking advantage of the lower prices to take an extra weekend trip.

Thus the gains from efficiency is lost in increased consumption. A classic example is lighting, which has gotten vastly cheaper per unit as the world has moved from lamp oil to candles to incandescent bulbs to fluorescent bulbs. Yet people now use more resources for lighting than we ever have in the past, since we have chosen to put lights almost everywhere.

Some opponents of the paradox say this is just a convenient theory that allows governments not to do anyhting about efficiency. Perhaps. But surely there is a truth in the theory. Human tendency has been to consume more of what is saved. Once your spending budget is fixed, any amount released from one product inevitably ends up in another basket, right?

Write in your views, while we bring you another post on efficiency.

Monday, August 29, 2011

Fuel from paper!

While on cars and fuels, Tulane University scientists have discovered a novel bacterial strain, dubbed "TU-103," that can use paper to produce butanol, a biofuel that can serve as a substitute for gasoline.

TU-103 is the first bacterial strain from nature that produces butanol directly from cellulose, an organic compound.

Cellulose is found in all green plants, and is the most abundant organic material on earth, and converting it into butanol is the dream of many. In the United States alone, at least 323 million tons of cellulosic materials are known that could be used to produce butanol are thrown out each year.

TU-103 is the only known butanol-producing clostridial strain that can grow and produce butanol in the presence of oxygen, which kills other butanol-producing bacteria. Having to produce butanol in an oxygen-free space increases the costs of production.

As a biofuel, butanol is superior to ethanol (commonly produced from corn sugar) because it can readily fuel existing motor vehicles without any modifications to the engine, can be transported through existing fuel pipelines, is less corrosive, and contains more energy than ethanol, which would improve mileage.

So, pick your choice, hydrogen or butanol?

Hydrogen filling stations soon

Germany will become the first country completely accessible to fuel cell vehicles in 2015, when carmaker Daimler and the Linde technology group will build 20 new hydrogen filling stations.

The result will quadruple the number of public stations available and make it possible for a fuel cell vehicle to reach any location in the country. Installation of the hydrogen refueling pumps will begin next year at existing gas stations currently operated by various oil companies.

Fuel cell vehicles are essentially a different kind of electric car. Fuel cells generate electricity in a chemical reaction between hydrogen and oxygen, which yields only pure water vapor. In a battery electric, the electricity is already stored in the battery. In both cases, the electricity powers the vehicle's engine.

Daimler is building 200 cars for Germany, Norway and the United States this year. Seventy of those will be Mercedes-Benz B-Class F-CELL vehicles going to California. Daimler began manufacturing a small series of this model in late 2009, then quickly decided to make it the first fuel cell passenger car it would mass-produce.

So who said fuel cells are topics of fiction and james bond movies?!